New Style Candy Wrapping Instructions

TLC Creations New Style Candy Wrapping Tutorial
This tutorial may be printed for personal use only. ©2003 TLC Creations

These instructions apply to 1.55 oz. size HERSHEY'S® bars and Snack Size Bars.

DO NOT REMOVE HERSHEY'S PLASTIC WRAPPER!
Included with your wrapper order, will be enough clear adhesive stickers to complete your candy wrapping project. You will receive 3 stickers per wrapper. One sticker is for the back of the wrapper, and one sticker for each end of the wrapper.
Before you begin to wrap, it's a good idea to lift up the edges of the stickers to make it easier to grasp them while you are wrapping. Even if they stick back to the paper backing, it will still be easier to grasp one while you are trying to wrap.

Most candy wrappers require that you tape the ends of the HERSHEY'S® plastic wrapper to the back of the candy bar. You will not need to do this using our New Style wrappers! Our wrappers will completely cover HERSHEY'S® 1.55 oz. new plastic wrapper, including the ends!

The next step is to line up the front of your wrapper with the candy bar. Holding the bar and wrapper up to a light source can be helpful in this step. You will be able to see the candy bar shadow through the wrapper and center your wrapper perfectly!

Now fold the top of the wrapper towards the back of the candy bar. Do not crease the paper yet!


Fold the back of the wrapper around the bar. Line up the edges on the ends of the bar to make sure they meet squarely.

Once your wrapper is lined up on the bar, you can crease the folds. You can also "pinch" the edge to make a crease if it is easier for you. This is sometimes necessary with glossy paper due to the heavier weight of the paper.

After creasing, make sure that the sides of the wrapper are still even. If so, then take a clear adhesive sticker and apply it to the center back of the wrapper joining the front to the back.
Note that for glossy paper, you will have to press the stickers on rather hard or they could pop open. If this does happen, just press the sticker down again and using a gentle rubbing motion, burnish them with your finger tips.

Next, you will do the same to each side of the candy bar by using one sticker per side to close them as shown below;

Once applied, the stickers are barely visible! Your guests can just open one end of the wrapper and pull out the candy bar without destroying the wrapper!

Your finished candy bar should look like this;

Web Site, All Graphics, Photos and Wrapper Designs
Copyright © 2006 TLC Creations.
All rights reserved.

Trademarks indicate products manufactured by Hershey Foods Corporation.
There is no affiliation between Hershey Foods Corporation, its divisions or subsidiaries, and TLC Creations.